Repair A Cat5 Cable ?

Introduction

This guide volition cover removing a damaged RJ-45 connector from an Ethernet cablevision and the steps to replacing it with a new one using the T568B standard. This requires a wire cutter/stripper/crimper tool and an RJ-45 connector.

• First let's identify which side of the tool performs which functions.

• One side of the tool is used for stripping wires. You can tell because it has two blades, one on each side, as indicated in the showtime photo.

• The other side is used for cutting wires. You tin can tell considering one side is bladed while the other is flat, as seen in the 2nd photograph.

• If yous are using a slightly different tool, the use of it will all the same be very similar to how it is shown in this guide.







• Place the wire across the bract of the wire cutter.

• Clasp the handles of the tool together until the wire is cut.

• When you are done with this step, the cablevision will announced as it does in the second photo.

• Place about a quarter of an inch of the cable into the stripping end of the tool.

• Clasp the handles of the tools together until the tool clicks and and then release.

• Pull the stripped wire cover from the cablevision with your fingers.

• Note: If your wire cutter does not take a side specifically for stripping wires, you can only use the wire cut role but do not clasp the handles all the style down, then that it only cuts the outer casing of the cablevision.

• When you have successfully completed this footstep, the cable should appear similar to the second photo of this step.

• Organize the wires in the proper club.

• This society is: Orange-white, Orange, Light-green-white, Blue, Bluish-White, Light-green, Brown-white, Brown.

• Hold these wires closely together and use the wire cutter to cut the very end of these wires off, to brand them all fifty-fifty in length.

• Hold the wires closely together in the gild shown in the previous step and button them into the new RJ-45 connector, with the prune cease of the connector facing down, and the orangish/white wire to the left.

• Push the wires to the end of the connector ensuring that all wires enter their respective chambers in the connector.

• If you inspect the top of the connector you should be able to see the tips of the wires pushed confronting the terminate of the connector, as shown in the second photo in this step.

• Place the RJ-45 into the crimper at the terminate of the tool. Push it in all the way, it will fit exactly in the tool—you tin can not push button it in too far.

• Clasp the handles of the tool together until it clicks and releases.

Determination

Y'all have at present replaced the RJ-45 connector, yous may test the fix by using the cable. If it does not work, y'all tin always follow the steps in this guide to endeavour again.

Team

Embed this guide

Choose a size and copy the code below to embed this guide every bit a small widget on your site / forum.

Preview

Source: https://www.ifixit.com/Guide/Ethernet+Cable+RJ-45+Connector+Replacement/62127

Posted by: knowltonthumbell.blogspot.com

Share this post